Installation Instructions for Turncraft Craftsman Column Wraps

Caution: The precision machined edges of Poly-Classic Craftsman column components can be extremely sharp. Use of appropriate personal protection equipment is required.

Measure overall opening from floor to beam or soffit (must have structural pressure-treated post or lally column for load support.)

Trim shaft pieces to 2-1/4" shorter than opening—2" for cap/base, 1/4" for expansion (1/4" if not using cap and base—each part is 1" thick.) Always trim from bottom ONLY- top is marked.

Slide 3/4 cut base platform section around post.

Glue base platform pieces using biscuits (supplied). Center and attach base to floor/pedestal with appropri-ate fasteners.

Lay 3 panels flat and apply adhesive to center joints. (Poly-urethane glue is recommended. Follow manufacturer's instructions.)

Assemble three panels, using E-Z Lock joints.

Finish nail three panels together.

Slide assembled 3-sided column around support (on top of base plat-form).

Slide 3/4 cap platform section into place on top of column panels.*

Raise 3/4 cap platform section to beam/soffit, center, and attach. There should be 1/4" space for expansion between column and cap platform.

Apply adhesive to final panel.

Assemble final panel to col-umn using E-Z lock joint. Nail panel to secure in place.

Apply glue to final 1/4 cap piece and biscuits and slide into place. Pin nail cap moldings to top of column.*

Use column shaft to check length of base trim molding. If trim is too long, mark cut lines for miters. Moldings should be about 1/8” longer than the width of the column.

If base trim moldings are too long, use miter saw to cut base trim pieces to fit around bottom of column.

Center trim moldings around shaft. Apply adhesive to base trim moldings and pin-nail into base platform. (Do not attach to shaft.) There should be about a 1/16" gap around shaft.

Caulk using latex caulking compound to fill any gaps and nail or screw holes.

Clean surface of column with cleaner recommended by the paint manufacturer. Paint with 2 coats of acrylic latex paint.

Please note the correct assembly of the E-Z Lock joint shown at the left. Nails MUST be installed only in the edges shown (3 and 4). Installing on the other edges may result in open seams.
1) Glue both joint edges; slide first joint together
2) Push second joint closed
3) Nail this joint first
4) Nail this joint second
Notes:
Panels are marked “TOP” — trim from the bottom only. Cap and base pieces are also marked as “CAP or “BASE” Only use non-corrosive fasteners — galvanized, stainless steel, etc.
Always follow glue and paint manufacturer’s instructions.
*Column must not be allowed to collect water, debris, etc. If the top of the column extends beyond the soffit/beam, the cap must be flashed with lead, copper, aluminum, etc. to prevent entry of water or foreign materials.

Note: If our standard sizes aren’t a perfect fit, tapered Craftsman columns are available in custom sizes and configurations. We can customize panel columns so there is a flat spot for your rail in just the right place. All Craftsman products are available in the wood of your choice on special order. We do not recommend the wood option for paint grade applications, the cost is higher and the PVC holds up better outside.

Just send us an email describing what you need:

Price quotes email: pagliacco@comcast.net